Oratape MT95 Clear Application Tape

Application Instructions

1. Once your adhesive vinyl design is cut and weeded, begin by cutting a piece of Oratape MT95 application tape that is the same approximate size as your image.
2. Carefully position the transfer tape over your image. It is typically best to begin on one side of the vinyl and work slowly and evenly toward the opposite side.
3. After the tape has been positioned, you will rub or burnish the tape in order to bond it securely to the vinyl image.
4. To burnish the transfer tape, use a vinyl application tool or the side of a credit card to apply firm, even pressure to the tape. Begin in the center, and work your way outward with smooth, slow strokes to ensure that there are no bubbles or ripples present.
5. Trim any excess tape from around the edges of your vinyl.

How to place the vinyl:

• – Once the transfer tape is prepped, slowly and steadily use it to peel the vinyl away from the carrier sheet.
• – Center your vinyl design onto the prepared surface.
• – Use your vinyl application tool to slowly and evenly smooth the vinyl onto the prepared surface. As before, begin in the center, and use firm, outward strokes to ensure that there are no ripples, wrinkles or bubbles.
• – Once the vinyl is burnished onto the surface, slowly peel up the transfer tape. For a smooth, seamless removal, begin with a single corner, and work your way across to lift the tape completely.